G-Wall

• EASY INSTALLATION & MAINTENANCE : One sensor per panel, modular product, which is easily set-up by non-technical personnel in a few hours and maintained/repaired if necessary in minutes
• RELIABILITY : Detection through vibration analysis provides a high probability of detection
• ROBUSTNESS : Extremely robust detector cable that can undergo extreme impacts and deliver intrusion information in seconds

G-WALL is designed to detect impacts on walls, by analyzing vibrations created during an intrusion attempt. Installed on interior walls, this product is suitable for monitoring large building structures such as warehouses, retail sites and transportation and logistics building facades.

G-WALL is easy to install as the sensor is fixed directly on the wall inside the building with a screw-on plastic component. The same applies to the control, termination or link units.

G-WALL is made up of 6 sections of 40 sensors per section which can be connected according to the building’s configuration. The cables are freely distributed between detection areas which can be up to 2400 linear feet (720 m) in each direction. Once installed and powered, the configuration and settings of G-WALL are set.

G-WALL technology provides a high probability of detection and is ideally suited for impact detection on walls. Sensitivity settings can be set-up based on the number of impacts. Settings and alarm logs are enabled remotely via the web server.

In areas where detection is not required (i.e. a gate), standard (non-detecting) electrical cable (passive) can be used to save on costs. Up to 656 ft. (200 m) of passive cable can be used per direction.

Part number: 93421901
Description: G-Fence 2400-IP65 Control Unit
Product type: Accelerometer-based intrusion detection
Link/Termination Unit (UR/UT) Part #: 40670204
Cable Roll 400ft - 40 sensors Part #: 40670206
G-WALL fixing kit (40 pack) Part Number: 93407901
API integration: yes
VMS integration: yes, through Smartbridge
Rohs Compliant: yes
Operating voltage: 12 / 24 VDC
Current consumption: 200 mA
Weight: 2.2 lb./1.0kg
Dry contact alarm relays: 10 Alarm + 1 Technical default + 1 Tamper
Alarm transmission modes: simultaneous Dry contact, API over IP and RS485 to MAXIBUS

To secure a wall and detect any intrusion attempt, a detector cable is installed on the wall panel. During an intrusion, the sensors will detect vibrations on the panel and send information to the Control Units, which in turn analyzes the information received before triggering an alarm, or not.

The cable is pre-assembled with -easy-to-install sensors helping to reduce installation costs.